509 EUROSAFE TEX

• 509 Eurosafe Tex is suitable for any type of subfloor that has a good
  tensile and compression strength. The subfloor should also be even, clean,
  permanently dry and free from grease and dirt, according to the requirements of
  BS 8203 or DIN 18 365.
• Only use pervious floor covering on impervious subfloors.
• When installing fillerfree carpet on impervious subfloors apply a 2
  mm levelling compound layer.
• In advance always seek our technical data sheets. In doubt about the
  application ask for technical advice.

User manual:

• Apply the adhesive with a regular notched adhesive spreader (Eurocol spreader no. 850/B1).
• On absorbent subfloors apply the floor covering directly into the wet adhesive. On low absorbent subfloors or impervious subfloors keep a waiting time of approx. 10 minutes (depending on porosity subfloor, temperature and relative humidity).
• When installing fillerfree carpet the subfloor should be moisture absorbent and keep a waiting time of approx. 20 minutes. Install fillerfree carpet only on absorbent subfloors.
• Roll the floor covering carefully. Sheet-ends and longitudinal joints are to be pressed firmly.
• On low absorbent subfloors, in case of impervious back qualities and/or when circumstances are less ideal, rolling and pressing should be repeated after approx. 15 minutes (depending on temperature, relative humidity, subfloor and floor covering).
• Remove fresh adhesive spots immediately with water.

Working conditions:
Required surrounding temperature : 18 – 23 °C.
Temperature for material and subfloor : min. 15° – max. 20 ºC.
Relative humidity : 40 – 80%.

Underfloor heating systems:
509 Eurosafe Tex can be applied on underfloor heating systems. The startprotocol of the floorheating needs to be completly executed in accordance with the directives of the supplier. Turn off the heater 24 hours before application. Do not heat again until at least 24 hours after installation, in steps of maximum 5 °C water temperature per day.

Contains methylchloroisothiazolinone and  methylisothiazolinone (3:1) and benzisothiazolinone. May produce an allergic reaction.